This should only be seen by the programmer when testing from his IP address.
If you see this message please contact the programmer.
A spider BOT has been detected and is not counted.
WHAT KIND OF OUTPUT WOULD YOU LIKE?
Choose
Output
Type
Imperial Options
Imperial
Thread
Half
Nuts
IMPERIAL THREAD
using Threads Per Inch (TPI)
Carriage
Feed
Imp
Longitudinal Feed Rate
using inches/turn.
Request a power feed rate for the carriage in inches/turn.
The feed gear ratios can be changed using the OPTIONAL ENTRIES menu button.
Cross
Feed
Imp
Cross slide feed rate
using inches/turn
Request a power feed rate for the cross-slide in inches/turn.
Diametral
Pitch
Worm
Gear
DP Diametral Pitch
teeth /inch
Used for cutting worm gears,
DP is distance between teeth, divided by diameter of the gear wheel.
Metric Options
Metric
Thread
Half
Nuts
METRIC THREAD:
mm pitch
Request the mm pitch for a metric thread
NOTE: You cannot use the THREAD DIAL INDICATOR to cut a metric thread on an imperial lathe and the half-nuts cannot be disengaged. Use the yellow button for instructions and exceptions.
Carriage
Feed
Met
Longitudinal Feed Rate
in mm/turn
Request a power feed rate for the carriage in mm/turn.
The feed gear ratios can be changed using the OPTIONAL ENTRIES menu button.
Cross
Feed
Met
Cross slide feed rate
in mm/turn
Request a power feed rate for the cross-slide in mm/turn
Modulus
Worm
Gear
Modulus for cutting worm gears
tooth pitch in mm
Request the modulus of a worm gear.
Imperial or Metric Option
Polygon
Polygon Cutter Adapter
Calculation of the gear train and gearbox settings
required to make a polygon e.g. square or hexagonal shaft.
using a polygon cutting adapter - click help (?).